top of page

Paid for a Patch That Failed? How to Get It Fixed Right

sp8002
Jul 3
4 min read

The patch looked fine the day the crew packed up. Eight months later it has sunk into a dish, the edges have cracked loose, and water sits in it after every shower. You paid real money for this.

Worse, the installer has gone quiet. Two calls went to voicemail. A text got a thumbs-up and then nothing. Here is what you can actually do, in order, and how to make sure the redo cannot fail the same way.

What the Consumer Guarantees Act says about a failed repair

Trade work in New Zealand is covered by the Consumer Guarantees Act. A repair must be carried out with reasonable care and skill, be fit for purpose, and last a reasonable time. An asphalt patch that breaks up inside a year fails that test in most circumstances. A properly built patch on a residential driveway should last many years, not months, so early failure points to the workmanship rather than the material.

If the work does not meet those guarantees, the installer must put it right within a reasonable time. If they refuse or simply stop responding, the Act lets you have someone else do the work and recover the reasonable cost from them, or in serious cases reject the work and seek a refund. This is general guidance, not legal advice. The facts of your job matter, and Citizens Advice Bureau or a community law centre will talk through your situation for free.

One thing that helps at every stage: dated photos. Photograph the failed patch now, from the same angles as any photos you took when the job finished. A defect with a timeline is far harder to argue with than a defect with a story.

The recourse ladder, one rung at a time

Most disputes settle early. Work up the ladder and keep everything in writing.

  1. A written request. Email the installer, describe the failure, attach dated photos, and ask them to inspect and remedy it. Give a specific response date, about ten working days. Phone calls fix nothing you can later prove.

  2. A deadline letter. If they ignore you, send a second message stating that the work has failed the Consumer Guarantees Act's requirements, that you require the remedy by a set date, and that after that date you will have the work done elsewhere and pursue them for the cost.

  3. Disputes Tribunal. Cheap to file, no lawyers on either side, and the referee's decision is binding. The claim limit comfortably covers any residential asphalt repair. You will need your original invoice, your photo timeline, your written requests, and a quote for the corrective work.

  4. Move on. If the installer has folded or vanished, weigh the chase against the fix. More on that below.

Notice what every rung needs: the invoice, the photos, the written trail, and a real number for the redo. Gather those first and the rest is administration.

Why the patch failed: the usual four shortcuts

Early patch failure is rarely bad luck. Almost every sunken or crumbling patch we get sent photos of shows one of the same four shortcuts:

  • No cut-back. The mix was smeared into the hole as found, so the patch bonded to broken, contaminated edges instead of sound asphalt.

  • No compaction. Hand-tamped or wheel-rolled instead of plate-compacted, so the patch densified under traffic and sank into a dish.

  • Cold joints. No tack coat and a cooled edge mean the joint between old and new never sealed, so water got in on day one.

  • Thin lift. Too little material over a soft base looks fine for a season, then cracks through.

A good repair is deliberately bigger than the hole it fixes, and there is a reason for that. We cover the mechanics in why cheap patches fail. Understanding the failure mode matters here, because it tells you exactly what to demand next time.

What to demand in the redo spec

Whoever does the corrective work, get these items in writing before you accept the price. They close off each of the four failure modes:

  • Saw-cut back to sound asphalt, past the visible damage, with straight edges

  • Base inspected and recompacted, with any soft material replaced

  • Hot mix laid and plate-compacted, not cold mix smeared in

  • Tack coat on all joints between old and new surface

  • A dated before/after photo record supplied on completion

Any contractor doing the job properly will agree to all five without hesitation. Anyone who hedges is telling you something. If you are quote-shopping, the warning signs are predictable, and we have listed the cowboy red flags to check before you pay.

When chasing costs more than fixing

Be honest about the maths. A standard patch done properly starts from $450, quoted as a fixed price from your photos. If the failed installer has stopped trading, changed numbers, or was a cash-job operator with no invoice trail, months of pursuit can cost you more in time than the repair costs in money, and the pothole keeps growing while you wait. Our guide to pothole repair costs in Auckland sets out what corrective work realistically runs to.

A useful middle path: get the redo priced and done, keep every receipt, and pursue the original installer for the documented cost afterwards. You get a working driveway now and your claim gets a concrete number.

Getting the redo priced from a photo

Take three photos: a wide shot of the failed patch, a close-up of the worst edge, and one with a coin or tape for scale. Then send us the photos for a fixed price. You get a written fixed quote within 24 hours, work is booked with a deposit and the balance before the scheduled day, paid by bank transfer or card, and you receive a dated before/after photo report on completion. That report is the paper trail the first job never gave you.

 
 
 

Comments


bottom of page