Subgrade CBR and Auckland clay — why some streets keep failing in the same spot
Updated: Oct 8
If you live on a street where the same potholes keep coming back in the same spots no matter how many times the road crews patch them, you're probably on low-CBR subgrade. CBR — California Bearing Ratio — is the engineering number that says how much load a soil can carry before it deforms. It's the single biggest predictor of how long any pavement will last, and it varies dramatically across Auckland depending on the underlying geology.
This page explains CBR in plain English, walks through where Auckland's good and bad subgrade is, shows what a contractor does differently when the subgrade is poor, and is honest about what a $350 Quick Fix can and can't achieve when the underlying soil is the problem.
CBR in plain English
The CBR test was invented by the California Highway Department in the 1930s. It's deliberately simple: you push a standard piston into a soil sample at a standard rate and measure the force. Then you compare that force to the force needed to push the same piston the same distance into a sample of compacted crushed rock. Your soil's CBR is the ratio, expressed as a percentage. Crushed rock scores 100. A clay that takes a quarter of the force scores 25. A soft saturated clay that barely resists at all scores 2.
The test is run at the soil's natural moisture content and also after it's been soaked, because soils change CBR dramatically when wet. The "soaked CBR" is what gets used for pavement design because Auckland's wet enough to assume the subgrade will be saturated at some point.
Typical Auckland subgrade CBR ranges
Auckland's geology is split into roughly four zones, and each has its own typical CBR signature.
East Coast Bays / North Shore sandstones — CBR typically 8-15 (good). Free-draining, reasonably stable, the easy end of Auckland to build on.
Waitemata-group mudstones (central isthmus, much of West Auckland) — CBR 4-10 (moderate). Plastic when wet, stiff when dry, design has to assume the wet end.
Manukau / South Auckland allophanic clays — CBR 2-6 (poor). The headline number. These are the soils that produce most of South Auckland's recurring pothole streets.
Kumeu / Helensville-Riverhead allophanic clays — CBR 2-5 (poor). Same family as Manukau, slightly different mineralogy, same construction headaches.
Volcanic basalt (Mount Eden, One Tree Hill, Manukau's volcanic cones) — CBR 15+ (excellent). Why some of the oldest streets in central Auckland still have their original 1920s seal intact.
How to spot a low-CBR street
Three giveaways. The first is repeat-spot failure. If the same 1-metre section of the road has been patched three times in five years, the patch isn't the problem, the soil under it is. The second is alligator cracking — a network of interconnected cracks that looks like alligator skin or dried mud. That pattern means the asphalt is fatigue-cracked from flexing over a weak subgrade.
The third is rutting in the wheel paths — visible depressions where car tyres run. Rutting on a clay subgrade is the soil literally squeezing out sideways under wheel loads. Once you've seen it, you can pick it out from 100 metres away.
What contractors do differently on low CBR
Three design responses make the difference between a 3-year and a 15-year pavement life on poor subgrade.
First, deeper sub-base. On a CBR-15 site, 150 mm of compacted M/4 basecourse is plenty under residential asphalt. On a CBR-3 site, that doubles to 300 mm or more, with a structural geofabric (woven polypropylene, like Bidim or Terram) at the interface to stop subgrade fines from migrating up into the basecourse.
Second, subgrade stabilisation. On really bad sites, the top 200-300 mm of subgrade can be mixed with lime or cement to raise its effective CBR by a factor of 3-5x. That's a specialist process — not something we do on a $700 patch — but it's standard practice on new subdivision roads in South Auckland for exactly this reason.
Third, drainage. We covered drainage in detail in another piece. The link to CBR is direct: a saturated clay can drop its CBR by 50% or more compared to its dry value. Keep the subgrade dry and you've effectively upgraded its bearing capacity for free.
Why a $350 Quick Fix is honest about its limits
The Rapidpatch Quick Fix at $350 is exactly what it sounds like — a fast, fixed-price emergency repair to make a pothole safe and serviceable. We don't dig down to the subgrade. We don't replace sub-base. We don't lay geofabric. We saw out the broken asphalt, clean the hole, and lay properly-compacted cold-mix or hot-mix back in. On good subgrade (CBR 8+), a Quick Fix can last 4-5 years. On Manukau allophanic clay with active pumping, the same patch might last 18 months.
The $700 Permanent gets to a saw-cut square edge with a proper tack coat — better seal at the patch joint — but it still doesn't reach the subgrade. The $700 expects an 8-12 year life on good ground; on poor ground, halve it. The $1,400 Multi-Patch is the same calculation across six holes.
When the subgrade is the real issue — alligator cracking across half the carpark, recurring same-spot failures — we'll say so. The honest answer is a $160-$180/m² resurface with proper sub-base depth and geofabric, or in extreme cases a full reconstruction with subgrade stabilisation that needs a civil-engineering scope rather than a patch quote.
How this affects your Rapidpatch quote
When you send a photo, we look for the signs of low-CBR subgrade — alligator cracking, repeat-spot failure pattern, soft edges around the hole. If we see them, the quote line will say so and the expected-life estimate is adjusted. You'll see the trade-off in writing so you can choose between a $350 Quick Fix that buys 18-24 months and a $160-$180/m² partial resurface that addresses the structural cause.
Frequently asked questions
Can I find out my street's CBR without commissioning a test?
Approximately, yes. The Auckland Council GIS has a geology layer — you can see whether your address sits on Waitemata mudstone, Manukau clay, basalt or sandstone. That gives you the ballpark. A site-specific test costs $800-1,500 from a geotechnical engineer and is normally only done for new construction or major reinstatement.
Does Rapidpatch ever do subgrade stabilisation?
No — that's a heavy-civil scope. Where we see a job that genuinely needs it, we'll say so and you can put it to a civil contractor.
Can I improve my CBR myself?
Indirectly, yes — by keeping your subgrade dry. Clean the channels, keep the sumps clear, sort out gutter overflow that's dumping water on the driveway. Dry clay performs 1.5-2x better than wet clay.
Is a Multi-Patch worth it on low-CBR streets?
Often yes — $1,400 across six potholes is cheaper than six separate $350 callouts, and it buys you 3-5 years even on poor ground. We'll tell you when it's better value than partial resurfacing.



Comments