How Much Does a New Concrete Driveway Cost in Auckland (2026)?
Short answer. A new plain concrete driveway in Auckland costs about $150 to $300 per m² + GST in 2026, including base preparation, mesh and a broom finish. Exposed aggregate, colour or a stamped finish adds about 20 to 50%. A 40 m² single driveway in plain concrete is about $6,000 to $12,000 + GST. Taking out an old driveway is extra. Rapidpatch prices new concrete driveways, patios and paths across Auckland: send photos and the rough size, and you get a price range the same business day, then a fixed written price after a free site measure.
Updated 13 November 2026.
Price per m² by finish (Auckland, 2026, excluding GST)
Plain concrete, broom or brushed finish: about $150 to $300 per m², including excavation, compacted basecourse, boxing, mesh, pour and finish.
Coloured concrete (oxide): adds about 10 to 30% to the plain price.
Exposed aggregate (with or without black oxide): usually 20 to 50% more than plain.
Stamped, stencilled or patterned finishes: usually 20 to 50% more than plain, depending on the pattern.
Concrete pavers on a new base: about $150 to $300 per m². Natural stone costs more.
Paths and patios: about $120 to $250 per m², with a minimum charge on small jobs.
Permeable concrete or permeable pavers: priced per job. The deeper open-graded base means it usually costs more than plain concrete.
Removing an old driveway: usually about $50 to $150 per m² extra, more for thick or reinforced slabs.
Worked totals for plain concrete
30 m² (a short single drive): about $4,500 to $9,000 + GST.
40 m² (a typical single drive): about $6,000 to $12,000 + GST.
60 m² (a double drive): about $9,000 to $18,000 + GST.
100 m² (a long or shared drive): about $15,000 to $30,000 + GST.
Small jobs cost more per m², because the crew, truck and set-up cost about the same whatever the size. What pushes a job to the top of the range: taking out an old slab, soft Auckland clay that needs digging deeper, a steep or tight site where the concrete has to be pumped, a mix of finishes, and drainage work.
What's included, and what costs extra
Included in the per-m² guide price: excavation to depth, compacted basecourse, boxing, reinforcing mesh, the pour, your chosen finish and saw-cut control joints.
Usually extra:
removing and disposing of the old driveway;
digging out soft clay and replacing it with more basecourse;
a concrete pump where the truck can't reach;
a cesspit, channel drain or stormwater connection;
retaining walls;
the vehicle crossing between your boundary and the road, which needs council approval. See vehicle crossing approval and cost.
Remove and replace an old driveway
If you're replacing a worn driveway, the old surface has to come out first. Removal and disposal usually adds about $50 to $150 per m², depending on the slab's thickness and reinforcing and how easily a digger can reach it. If the old drive is asphalt in fair shape, an overlay may be the cheaper answer: see driveway resurfacing options. If it's cracked concrete you might keep, see concrete repair first.
Choosing a finish
Plain or broom finish: the cheapest and most practical. On a steep drive, the broom lines run across the slope for grip.
Exposed aggregate: the top layer of cement is washed off to show the stones. It hides dirt and tyre marks well. Angular stone and a non-gloss sealer give better grip than rounded pebbles.
Coloured (oxide): pigment mixed through the concrete. Black and charcoal are the most popular in Auckland. The colour itself is stable; it's the sealer on top that wears and needs renewing.
Stamped or stencilled: patterned to look like pavers or stone. Needs regular sealing.
New concrete won't match an old slab exactly at first. It's lighter, and it blends in over a year or two.
Concrete patios, paths and courtyards
Paths for foot traffic only can be thinner than a driveway, usually 75 mm minimum. Patios should fall away from the house so water doesn't pool at the door. Small areas carry a minimum charge, so it's often worth doing a path and patio in the same visit.
Pavers or poured concrete?
Pavers can be lifted and relaid if a pipe needs fixing, and look good, but they need weeding and can settle if the base isn't right. Poured concrete costs less to look after and lasts 30 years or more on a good base. For a full side-by-side with asphalt, see asphalt vs concrete driveways.
Permeable concrete and Auckland's impervious-area rules
Permeable concrete has open voids, so rain soaks through into a deep stone base instead of running off. That matters in Auckland because of the Unitary Plan:
Porous or permeable paving doesn't count as "impervious area" under the Unitary Plan definitions (Chapter J).
Most residential zones (Single House, Mixed Housing Suburban and Mixed Housing Urban) cap impervious area at 60% of the site.
On sites in a Stormwater Management Area Flow overlay, more than 50 m² of new or redeveloped impervious area usually needs resource consent.
So on a site that's close to its limit, a permeable driveway can be the difference between needing consent and not. The trade-offs: permeable surfaces clog with fine silt unless they're swept regularly, Auckland clay often needs an underdrain to carry the water away, and there's no single New Zealand installation standard yet. It's priced per job after a site measure. Check your own site's zone and overlays with the council before you rely on this.
How a concrete driveway is built
Thickness: at least 100 mm for cars and light vehicles, 125 to 150 mm for heavier vehicles or a shared driveway.
Base: compacted basecourse, deeper on soft ground. Auckland Council's driveway guidance asks for a 150 mm sub-base where the ground is soft.
Reinforcing: steel mesh in the upper part of the slab with about 30 mm of cover, or fibre where the design allows.
Joints: saw-cut control joints at regular spacing so the slab cracks along the cuts, not across the middle.
Fall: at least 1 in 100 so water runs off, and a maximum grade of about 1 in 5.
Curing: kept damp for the first few days. Cars can usually go on after about 7 days, heavy vehicles after about 28 days, longer in cold weather.
Consent, widths and the vehicle crossing
A concrete driveway laid on the ground doesn't usually need a building consent. A retaining wall that holds up a driveway does need building consent, whatever its height, because the driveway counts as extra load. A new or wider driveway can push a site over its impervious-area limit (see above), and the vehicle crossing in the road reserve always needs council approval: see vehicle crossing approval and cost. For a single house, a driveway is usually at least 2.5 m wide; shared driveways need more.
Sealing and upkeep
Coloured, exposed aggregate and stamped finishes should be sealed. Most sealers need redoing every 2 to 3 years. A simple test: sprinkle water on the surface. If it beads up, the sealer is working. If it soaks straight in, it's time to reseal. Sealing is priced per job.
Already have a cracked concrete driveway?
Not every cracked driveway needs replacing. Hairline cracks, a broken panel or a lifted edge can often be repaired for a fraction of the cost. See concrete repair in Auckland and concrete driveway repair cost.
How to get a price
Send us:
3 or 4 photos of the area;
the rough size (length × width);
the finish you'd like;
what's there now (grass, old concrete, gravel or asphalt);
the slope and how a truck would get in;
when you'd like it done.
You get a price range the same business day, then a fixed written price after a free site measure. Auckland only. Outside Auckland, send the same details and we'll put you in touch with a vetted local crew.
New concrete driveway questions, answered
How much does a concrete driveway cost in NZ?
In Auckland, a new plain concrete driveway costs about $150 to $300 per m² + GST in 2026, including base preparation, mesh and finish. Exposed aggregate, colour or stamping adds about 20 to 50%. Prices outside Auckland vary by region.
How much does a 30 m² concrete driveway cost?
About $4,500 to $9,000 + GST in plain concrete in Auckland, before removing any old surface. Small jobs cost more per m² than large ones.
How much is exposed aggregate concrete per m²?
Exposed aggregate usually costs 20 to 50% more than plain concrete. With plain concrete at about $150 to $300 per m² + GST in Auckland, exposed aggregate typically sits at the upper end of that range or above it.
How much does it cost to remove and replace a concrete driveway?
Removal and disposal usually adds about $50 to $150 per m² + GST to the new driveway price, depending on the old slab's thickness, reinforcing and access.
Is it cheaper to asphalt or concrete a driveway?
It depends on what you start with. Resurfacing a sound asphalt drive with an overlay is usually the cheapest option. For a full new build, compare like-for-like quotes that include the base. See asphalt vs concrete driveways.
How long before you can drive on a new concrete driveway?
Cars can usually go on after about 7 days, and heavy vehicles after about 28 days. Allow longer in cold weather.
How thick should a concrete driveway be in NZ?
At least 100 mm for cars and light vehicles, and 125 to 150 mm for heavier vehicles or a shared driveway, on a compacted base.
Do I need council approval for a concrete driveway in Auckland?
A driveway on your own land doesn't usually need building consent, but a retaining wall that holds up a driveway does, and a new or wider driveway can trip the impervious-area limits. The vehicle crossing in the road reserve always needs council approval.
Is permeable concrete more expensive?
Usually, yes. Permeable concrete needs a deeper open-graded stone base and often an underdrain, so it costs more than plain concrete. It's priced per job. The upside is that permeable paving doesn't count toward the site's impervious-area limit in Auckland.
Does black oxide concrete fade?
The oxide pigment itself is colour-stable. What wears is the sealer on top, which makes the colour look duller as it goes. Resealing every 2 to 3 years keeps it dark.
How much does a concrete patio cost in New Zealand?
In Auckland, a plain concrete patio or path is about $120 to $250 per m² + GST, with a minimum charge for small areas. Decorative finishes cost more.
Planning a new concrete driveway, patio or path in Auckland? Send 3 or 4 photos, the rough size and the finish you want. You get a price range the same business day, then a fixed written price after a free site measure. Or call 027 737 2858.


Comments