Tar Seal Repair NZ: Tarseal Driveway Patching, Cost and Options
Updated: Nov 9

Short answer. Tar seal (also written tarseal or tar-seal) is the Kiwi name for chip seal: sprayed bitumen with stone chip rolled into it. A pothole or broken patch in tar seal is repaired by cutting out the failed area and filling it with hot-mix asphalt, or, for a quick fix, with compacted cold-mix. Large areas of worn, stripped seal need a reseal instead. In Auckland, Rapidpatch patches tar seal from $350 + GST for a single small hole, and a permanent saw-cut hot-mix patch starts from $700 + GST. Send two photos and you get a fixed price back, usually within 10 minutes during business hours.
Updated 7 November 2026.
Most New Zealanders use tar seal and asphalt as if they mean the same thing. They don't, and the difference decides which repair lasts and which one fails inside a winter.
What tar seal actually is
Tar seal is the New Zealand name for chip seal. A contractor sprays hot bitumen onto a prepared basecourse, scatters crushed stone chip over it straight away, and rolls the chip in while the bitumen is still tacky. No mixing plant, no hot-laid mat. The bitumen holds the chip and waterproofs the base underneath.
Modern tar seal contains no tar. It's bitumen, a heavy residue from refining crude oil. The name stuck from the days when coal tar was used. You'll also hear sprayseal, two-coat seal, or just "the seal". Some people say tarmac, which strictly is a different (asphalt) product, but on a Kiwi driveway it usually means the same black surface.
Tar seal covers most rural and lifestyle-block driveways in NZ, plenty of older suburban drives and right-of-ways, and much of the rural road network, because it's cheap to lay over long distances.
How tar seal fails, compared with asphalt
Asphalt is a solid mat: bitumen and aggregate mixed hot and rolled into a slab. It cracks first, breaks into pieces, then potholes where water gets under it.
Tar seal fails by losing its chip. Sun oxidises the bitumen, it goes brittle and lets go of the stones. You see bald grey or black patches, then bare basecourse. Once water reaches the basecourse a small bald patch becomes a soft spot, then a pothole, often within one wet winter.
Other common tar seal problems:
Bleeding: bitumen rising through the chip on hot days and going sticky. Annoying, rarely structural.
Point-load damage: a digger track, a skip bin foot or a heavy ute parked in the same place every day.
Edge break: the unsupported edge of a seal crumbling into the grass or gutter.
Fuel and oil spills: these soften bitumen and leave a weak spot.
Tar seal repair options and when to use each
Cold-mix patch: pre-mixed asphalt shovelled into the hole and compacted. Drive on it the same day. Fine for one or two isolated holes on a residential drive. Expect two to five years under light traffic.
Hot-mix asphalt patch (permanent): the crew saw-cuts around the failure, removes broken material, tacks the edges and lays hot asphalt compacted in place. It's the permanent fix when the base is dry and sound. The patch is a smooth black rectangle in a textured surface, so it won't match the chip look straight away.
Spot reseal: sweep, spray fresh bitumen, spread new chip, roll. Right for patches of stripped or oxidised seal that haven't broken into the base. Not for actual potholes, because the bitumen needs something solid to sit on.
Full reseal: the whole drive or road resealed in one pass, usually every 10 to 15 years. Right when chip loss and oxidation are spread across most of the surface.
Hot-mix overlay: 30 to 50 mm of asphalt laid over sound tar seal. You end up with an asphalt driveway: smoother, no loose chip, higher cost.
Dig-out and rebuild: when the basecourse under the seal has failed, patching the surface only buys a year. The soft base is dug out, replaced and compacted, then surfaced.
Tar seal driveway cost NZ (2026)
What tar seal repair costs depends on area, depth and whether the base has failed. These are Rapidpatch Auckland prices for private driveways, right-of-ways and carparks:
Single small pothole, quick fix (cold-mix): from $350 + GST.
Two or three small holes, quick fix: from $480 + GST.
Permanent saw-cut hot-mix patch: from $700 + GST for a single small patch. Most driveway patches up to about 5 m² come in around $1,075 + GST.
Larger tar seal sections, about 8 to 30 m²: around $137.50 per m² + GST in hot-mix. A 20 m² front section of a worn chip seal drive priced at $2,750 + GST; a 30 m² section at $4,125 + GST.
Over 10 m², or where the base looks soft: we give an indicative range from your photos and confirm on site before a fixed price.
Full reseal or new tar seal over a long driveway: priced per job, usually through a specialist sealing crew. Long rural drives are often cheapest resealed in chip rather than overlaid in asphalt.
Prices assume the base under the seal is sound. If base failure turns up once the failed area is cut out, work stops and the extra is priced in writing before it goes ahead.
Outside Auckland we don't publish fixed prices. Send photos anyway: we'll tell you what the damage is and put you in touch with a vetted local crew.
How we quote tar seal from a photo
Tar seal looks different from asphalt in a photo and we read it differently: visible chip texture, grey-on-black patches where chip has stripped, lighter patches where basecourse shows, and ragged hole edges.
Send two photos: a wide shot showing the surrounding surface, and a close-up of the damage with something for scale (a phone, a boot, a coin). The wide shot shows whether the failures are isolated or the whole seal is tired. The close-up shows depth and whether the base looks dry or wet.
From those we tell you in writing whether it needs a cold-mix patch, a hot-mix patch, a reseal, or whether the honest answer is to wait and do the whole drive together.
When the seal isn't the real problem
Sometimes the seal looks rough but the failure is in the basecourse below. Signs: the surface flexes underfoot, water ponds in a dip, or there's a bowl shape rather than a sharp-edged hole. Patching the seal in that case buys about a year. The proper fix is to dig out the soft base, replace and compact it, then surface. A photo quote sorts out which one you have before you spend anything.
Thinking of overlaying the whole tar seal drive in asphalt? See driveway resurfacing for overlay costs and the level checks.
Frequently asked questions
Is tar seal the same as asphalt?
No. Tar seal (chip seal) is sprayed bitumen with stone chip rolled in on top. Asphalt is bitumen and aggregate mixed hot at a plant and laid as a solid mat. They look different, fail differently and are repaired differently.
Tar seal, tarseal, tar-seal or tarmac: what's the difference?
Tar seal, tarseal and tar-seal are the same thing spelled three ways: NZ chip seal. Tarmac strictly means an asphalt-type mix, but in everyday Kiwi use people say tarmac for any black driveway. Send a photo and we'll tell you which surface you have.
How much does tar seal repair cost?
In Auckland, a single small tar seal pothole starts from $350 + GST as a quick fix. A permanent saw-cut hot-mix patch starts from $700 + GST, and larger sections run around $137.50 per m² + GST. Over 10 m² we confirm on site first.
Can you patch tar seal with asphalt?
Yes. Hot-mix asphalt is the standard permanent patch for a pothole in tar seal. It bonds to the cut edges and lasts as long as the base underneath is sound. It looks smoother and darker than the chip around it.
Can you patch a tar seal pothole with cold-mix?
Yes, for one or two isolated holes on a residential drive. Compacted cold-mix bonds reasonably to the surrounding seal. Expect two to five years under light traffic.
How long should a tar seal driveway last?
A two-coat seal on a sound base with light traffic typically goes 12 to 18 years before it needs a full reseal. Heavy vehicles, a soft base, shade and moss, or coastal sun shorten that.
Why do I have loose stones everywhere from my tar seal?
Some chip loss is normal in the first weeks after sealing. Ongoing loose chip after a year usually means too little bitumen, oxidation, or a seal near the end of its life.
Can I put asphalt over tar seal?
Yes. A 30 to 50 mm hot-mix overlay over sound tar seal is a common upgrade, and the old seal becomes the base. Going back to chip seal later means milling the asphalt off.
Do you repair tar seal outside Auckland?
We price and repair in Auckland. For tar seal in other regions we'll look at your photos, tell you what the problem is, and refer you to a vetted local crew.
Tar seal breaking up, potholed or shedding chip? Send a wide photo and a close-up, plus the address. Auckland jobs get a fixed price back, usually within 10 minutes during business hours. Or call 027 737 2858.


Comments